36
English
1.
Connect the
PC IN / PC/DVI AUDIO IN
port of the TV to the PC/AUDIO port of the RJP.
2.
Connect the
AV IN [L-AUDIO-R]
port of the TV to the AUDIO port of the RJP.
3.
Connect the
AV IN [VIDEO]
port of the TV to the VIDEO port of the RJP.
4.
Connect the
HDMI IN(1, 2(DVI) or 3(ARC))
, HG890V model:
HDMI IN(1(ARC)
,
2
,
3(DVI))
port of the TV and the HDMI port
of the RJP.
5.
Connect the
RJP
port of the TV and the RS/232 port of the RJP.
✎
The RJP (Remote Jack Pack) compatible with this Samsung TV is TeleAdapt TA-7610, TA-7650 (HD) and TA-7660 (HD
Plus).
y
RJP (Remote Jack Pack)
: RJP stands for Remote Jack Pack. The RJP is a hardware module that has different Audio
Video inputs (A/V, Audio, PC and HDMI) and corresponding outputs. The corresponding output sources are connected
from RJP to TV. The RJP communicates with the TV via RS232. Hot Plug & Play is a function that allows hotel guests to
connect an external source to the RJP. The RJP communicates with the TV by sending messages regarding Active/Inactive
sources. The TV will switch to the Active external source according to the priority set by the User.
✎
You can select
HDMI IN(1, 2(DVI) or 3(ARC))
, HG890V model:
HDMI IN(1(ARC)
,
2
,
3(DVI))
and
AV IN
for connecting
RJP
.
✎
When the TV is on, connect the TV and the
RJP
within 10 seconds.
y
The RJP can be returned to the factory default settings by pressing the A/V and HDMI buttons simultaneously for 10
seconds. All LEDs blink 5 times to acknowledge that this has been finished.
y
The RJP will automatically turn off any LEDs after 5 minutes to avoid unnecessary light pollution in the hotel room. The
LEDs that were turned off will turn on again if the guest touches any of the buttons and the 5 minute timer will restart. If the
guest then touches another source button, the TV will change to the selected source and the corresponding LED will be lit.
y
After an RJP Reset or a TV Power OFF/ON, it takes approx. 10 seconds to establish communications between the TV and
the RJP.
y
The following table shows the approximate time in seconds to switch from the TV to the input source, based on the priority.
✎
Scenario 1: When no inputs are connected.
Source
To Connect
AV
2 Sec
PC
0.7 Sec
HDMI
3.9 Sec
✎
Scenario 2: When two or more inputs are connected and an Input source is disconnected and then reconnected.
Source
Disconnect
To Connect
Total
AV
4.5 Sec
2 Sec
6.5 Sec
PC
0.7 Sec
0.7 Sec
1.4 Sec
HDMI
3.9 Sec
3.9 Sec
7.8 Sec
✎
E.g. If the RJP has all its live sources AV, PC and HDMI connected, AV is viewed as the highest priority. If the RJP is
in HDMI mode, and a guest removes and reconnects the AV, the minimum time required to switch to the AV is 6.5
seconds.
y
To connect audio (Ipod or Mp3), Music mode should be ON.
y
A/V, PC and HDMI input sources are supported.
