17
Replacing Deodorization filter section
Deodori DNA filter is a high performance filter that removes not only the
harmful smells generated by furniture, wall paper, adhesives but also general odor.
When replacing the Deodorization filter, follow the procedure below.
1 . Pull out the Deodorization filter after opening the filter box.
2 . Widen each side of the filter frame with hands and pull out the
deodori DNA filter from filter frame.
3 . Put the new deodori DNA filter into the filter frame.
4 . After closing the filter box door, plug in the air purifier.
• Clean the pre-filter with running water when the filter cleaning alarm
display on the control panel is lit up.
• After cleaning the pre-filter with water, dry it completely and put it in
again. (The dry time of the filter might be different depending on the
seasons.)
• After cleaning the pre-filter, press the [Reset] button on the control
panel for more than 2 seconds. The filter cleaning alarm display on the
control panel will be off with the ‘beep’ sound. When the filter needs to
be cleaned, the filter cleaning alarm display will be lit up again.
• Sometimes, pre-filter cleaning alarm display might not be lit up
depending on the surrounding environment. However, you should
press [Reset] button for more than 2seconds whenever you finish
cleaning the filter.
• Lift up the pre-filter at the groove on the filter section handle(1), and
pull it out in the arrow direction(2).
• Changing the deodori DNA filter once a year is recommended.
However, the filter replacement period may be different depending on
the indoor air contamination level and hours of usage. Therefore, when
the strange smell is generated from the filter, purchase a new filter at a
service center or a retail store and replace it.
NOTE
Deodorization
filter section
Deodorization filter
➀
Pre-filter
➁
AC-M50ANSA Series_IB_EN_33977A(4).indd 17
2013-07-08 오후 6:07:07
