35
Commissioning & Maintenance Sheet
You will need a thermometer and a pen to complete this form:
The Unit
Model Number
From outdoor unit right hand side
Serial Number
From outdoor unit right hand side
Ambient Air Temp.
Measure this in the garden
Has the filter been cleaned?
Glycol Concentration %
Measure this
Has the coil been cleaned?
Has the unit been polished?
In Heating Mode
Water Flow Temp.
From remote controller
Water Return Temp.
Measure this
Flow Rate ( l/min )
From the flow meter
Temp of air at the back of unit
From remote controller
Flow Rate ( l/min ) when all rads
& UFH manifolds are closed
From flow meter
Cylinder
Cylinder model & serial number
Cylinder water temp at start up
Press view button on rc
Cylinder water temp after 30mins
Press view button on rc
Water flow temp
From remote controller
Water return temp
Measure this
Flow Rate ( l/min)
From flow meter
Immersion heater current
Press immersion button on rc
Immersion heater cutout setting
Remove cover and adjust to 70°C
Commissioning Data not required at maintenance
Where was the unit purchased
Date installed
Date delivered
( Proof of delivery required)
Warranty Starts from this date
Date commissioned
Samsung approved installer?
Would you like to be an
approved installer?
Warranty Years Required
3 / 5 / 7 Years
Installation Address
About the Engineer
Engineers Name
Company
Address
Engineers Telephone Number
Email Address
Signature of Engineer
Date
I accept the terms of the Samsung warranty and confirm the system has been registered within 30 days of delivery.
I also include a copy of the delivery note.
Signed
Name
Date
