ENGLISH-4
Safety precauti
o
ns
f
When you install the Air to water heat pump in a small room, you must consider a proper ventilation to prevent a leakage
level within the maximum permissible limit.
- In that case, you may die from su
ff
ocation by some possibility.
f
Make sure to safely dispose of packing materials. Packing materials, such as nails and other metal or wooden pallets may
cause children get injured.
f
Inspect the product shipped and check if damaged during transport. If the product has some damages, DO NOT INSTALL
and immediately discuss about the damages with the carrier or retailer (if the installer or the authorized technician has
collected the material from the retailer.)
f
Our units shall be installed in compliance with the spaces described in the installation manual, to ensure accessibility
from both sides and allow repairs or maintenance operations to be carried out. If the units installed without complying
with procedures described in manual, additional expenses can be asked because special harnesses, ladders, sca
ff
olding
or any other elevation system for repair service will NOT be considered part of the warranty and will be charged to the
end customer.
f
Always make sure that the power supply is compliant with local safety standards.
f
Verify that the voltage and frequency of the power supply comply with the speci
fi
cations and input power is su
ffi
cient to
ensure the operation of any other domestic appliance connected to the same electric lines. Always verify that the cut-o
ff
and protection switches are suitably selected.
f
Always verify that electric connections (cable entry, section of leads, protections…) are compliant with the electric
speci
fi
cations and with the instructions provided in the wiring scheme. Always verify that all connections comply with
the standards applicable to the installation of air to water heat pumps. Devices disconnected from the power supply
should be completely disconnected in the condition of overvoltage category.
f
Do not connect the earth wire to the gas pipe or water pipe, lighting rod, surge absorber, or telephone earth wire. If
earthing is not complete, it may cause an electric shock or
fi
re.
f
Be sure to install both an earth leakage detector and circuit breaker with speci
fi
ed capacity in accordance with relevant
local and national regulations.
- If it is not installed properly, it may cause electric shocks and
fi
re.
f
Make sure that the condensed water runs well out of the unit at low ambient temperature. Drain pipe and cond heater
can frost/ice can not grow. If drain work is not e
ff
ective for releasing condensed water, it can make the units get damaged
by massive ice and system can be stop , covered by ice.
f
Install the power cable and communication cable of the indoor and outdoor unit at least 1
m away from the electric
appliance.
f
Protect the unit from rats or small animals. If an animal makes a contact with the electric parts, it can cause malfunctions,
smoke or
fi
re. Please instruct the customer to keep the area around the unit clean.
f
Do not disassemble and alter the heater at your own discretion.
f
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play
with the appliance.
f
F
o
r use in Eur
o
pe :
This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play
with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
f
Be sure not to perform power cable modi
fi
cation, extension wiring, and multiple wire connection.
- It may cause electric shock or
fi
re due to poor connection, poor insulation, or current limit override.
- When extension wiring is required due to power line damage, refer to "How to connect your extended power cables" in
the installation manual.
