ENGLISH-9
02
INST
ALL
ATION
f
Do not install the Air to Water Heat Pump in following places.
•
The place where there is mineral oil or arsenic acid. There is a chance that parts may get damaged due to burned resin.
The capacity of the heat exchanger may reduce or the Air to Water Heat pump may be out of order.
•
The place where corrosive gas such as sulfurous acid gas generates from the vent pipe or air outlet. The copper pipe or
connection pipe may corrode and refrigerant may leak.
•
The place where there is a danger of existing combustible gas, carbon
fi
ber or
fl
ammable dust. The place where thinner
or gasoline is handled.
•
This device must be installed according to the national electrical rules.
•
With an outdoor unit having net weight upper than 60
kg, we suggest do not install it suspended on wall, but
considering
fl
oor standing one.
CAUTION
f
If the outdoor unit is installed at a height, ensure that its base is
fi
rmly
fi
xed in position.
f
Make sure that the water dripping from the drain hose runs away correctly and safely.
f
When you install the outdoor unit at wayside, you should install it above 2
m height or make sure that the heat from the
outdoor unit shouldn't be in direct contact with passersby. (The ground for application :The revision of regulation for
facility in building by the law of the Ministry of Construction and Transportation.
M
o
ving the Outd
oo
r Unit by Wire R
o
pe
Fasten the outdoor unit by two 8
m or longer wire ropes as shown at the
fi
gure. To prevent from damage or scratches, insert a piece of cloth between
the outdoor unit and rope, then move the unit.
❋
The appearance of the unit may be di
ff
erent from the picture depending
on the model.
Plate protection
cloth
Wire rope
