29
ENGLISH
Cleaning the Zero filter
Zero filter traps small dust particles within the air. It is washable and it can be used semi-permanently.
Remove the lower Full HD
filter. Grasp the handle on
the Zero filter and remove it
by pulling it in the direction
of the arrow shown in the
figure.
Push the Zero filter in the
direction of the arrow
and make sure it is fixed
in correct position. Put
the lower Full HD filter
back.
Soak the filter in the water and shake it up and down for
few times.
f
f
Do not disassemble the Zero filter when cleaning it.
f
f
If the accumulated dust is heavy, soak the filter in water
mixed with detergent and shake it in water for 30
minutes until it is cleaned.
Dry the filter in a ventilated area.
f
f
Put the filters vertically for 12~24 hours when drying
(Drying time can be shorter depending on the
condition)
f
f
Do not dry the Zero filter in direct sunlight. It may get
deformed.
•
Be careful with the sharp rear surface of the Zero filter. You may cut in your hands.
CAUTION
•
Clean the Zero filter every 3 months. (Based on 8 hours of use per day.) Cleaning term may differ depending on
the usage and environmental conditions.
NOTE
S-east_MEMORY_IBIM_EN_03955A-02_EN.indd 29
2014-10-28 오후 12:00:55
