Samsung AGTN1DKH Series, Installation Manual

3

English

Sa

fe

ty

 In

fo

rm

at

io

n

  WARNING

•  Hazards or unsafe practices that may result in severe 

personal injury or death.

  CAUTION

•  Hazards or unsafe practices that may result in minor 

personal injury or property damage.

General information

  WARNING

Using the fan coil unit

•  This product is for a centralized air conditioning 

control.

•  Failure to observe the following may cause 

condensation water to overflow, leading to water 
leakage.

– Do not turn off the power switch although the 

product is not used for a long time.

– Do not turn off the power switch immediately after 

stopping the operation.

– Be sure to attach a valve to each of the piping inlet 

and outlet.

•  When operating the product for the first time, purge 

air by using the air vent valve. Failure to do so may 
result in poor performance and noise.

•  Do not insert the air vent hose into the drain hole of 

the drain plate. Failure to do to may cause water to 
overflow from the drain plate.

•  Be sure to insulate the piping.
•  Do not use any heat medium other than water.
•  When the product is not used for a long time, drain 

water.

•  Before operating the product, make sure that the 

control valve is open.

•  Be sure to keep the start operation sequence of fan 

ʀͱ̷̈ĮĘ२˵ʪɇϩϑͱЇθʀʪĮĘɇ͝ʒϩ˵ʪϑϩͱΧͱΧʪθɇϩ̈ͱ͝
ϑʪαЇʪ͝ʀʪͱ˙˵ʪɇϩϑͱЇθʀʪĮ˜˜२˙ɇ͝ʀͱ̷̈Į˜˜ࢋ

•  Observe the following to prevent condensation in 

summer:

– Do not use the product in hot and humid places 

(relative humidity 80% or more). 
Water falling from the product may cause fire or 
property damage.

– To ensure 24-hour flow of cold water, be sure to 

install a 2-way electric valve. If not installed, water 
overflow and condensation may occur. 
When the fan coil unit is stopped, the interworking 
control with the 2-way electric value (valve closed) 
blocks cold water from circulating to prevent 
condensation inside the product. 
If no 2-way electric valve is installed, condensation 
water may be generated and condensation may 
develop inside the product.

– When the heat source (chiller, boiler) is not used for 

more than 4 hours during the Cool mode, stop the 
water circulation. 
If the water circulation cannot be stopped, operate 
the fan at a low speed.

•  Observe the following to prevent the piping from 

freezing and bursting in winter: 

– Use a circulation pump to keep water running, or 

run a hot water boiler in intense cold weather.

– If the product is not used for a long time, drain 

water from the entire system. 

•  When a season ends, drain water from the entire 

system, including the heat exchanger and the piping.

• 

Ǯ˵ʪ͝ϩ˵ʪϑЇΧΧ̷циɇϩʪθϩʪ͔ΧʪθɇϩЇθʪ̈ϑɇɵͱЭʪߧߦঐࡡ

the fan coil unit may enter the protection control mode 
(operation stopped) for product protection.

Before installing or maintaining the fan coil unit

•  Be sure to disconnect all power sources before 

installation, service, or cleaning.

Installing the fan coil unit

•  Make sure that installation must be performed by a 

qualified installer.

– If the product is installed by the customer and if 

it is not installed completely, it may cause water 
leakage, electric shock, or fire.

•  Install the product safely in a place that has enough 

strength to support the product weight.

•  If the strength is insufficient, the product may fall off, 

causing personal injury.

Safety Information