You must select the Cool mode if you wish to lower the temperature in your
room. You can also set the fan speed.
1
If necessary, press the
(On/Off) button.
Result:
◆
The operating mode indicator (COOL, FAN or HEATER)
on the unit comes on.
◆
The air conditioner starts up in the mode selected
when the unit was last used.
◆
The unit beeps twice.
☛
The air conditioner is fitted with a protection mechanism to prevent
the unit from being damaged when it is started immediately after
being:
◆
Plugged in
◆
Stopped
It will start up automatically after about three minutes.
2
If the COOL indicator is not lit up on the unit:
◆
Press the button on the remote control
or
◆
Press the button on the unit one or more times until the COOL
indicator lights up
Result:
◆
The unit beeps each time you press .
◆
The air conditioner starts up in Cool mode.
➢
You can change modes at any time.
3
To adjust the temperature, press the or
button on the remote
control one or more times until the required temperature is displayed.
To adjust the temperature, press the or
button on the unit one
or more times until the required temperature is displayed.
Possible temperatures are between 18°C and 30°C inclusive.
Result:
◆
Each time you press the temperature buttons:
– The temperature is adjusted by 1°C and
displayed on the control panel
– The unit beeps
◆
The air conditioner starts cooling if the room temperature is
higher than the selected temperature.
4
To set the fan speed to...
Then...
Result:
Each time you press a button, the unit beeps.
5
To control the direction of the air flow, refer to page 11.
Cooling Your Room
Remote Control
Control Panel
High
◆
Press the button on the remote control.
or
◆
Press the on the unit until the
indicator lights up
Med
◆
Press the button on the remote control.
or
◆
Press the on the unit until the
indicator lights up
Low
◆
Press the button on the remote control.
or
◆
Press the on the unit until the
indicator lights up
E-
8
