27
English
Instal
lation Pr
oc
edur
e
Setting Option
1
Remove batteries from the remote controller
2
Insert batteries and enter the option setting mode while pressing
button and
button.
3
Each time you press
button, 7-seg on left side is increased by “1” and each time you press
button, 7-seg on right
side is increased by “1”
4
You press
button to move to the next setteing page.
5
After setting option, press
button to check whether the option code you input is correct or not.
→
→
→
→
→
→
→
→
6
Press operation button
with the direction of remote control for set.
CAUTION
•
SEG1, SEG7, SEG13, SEG19 are not set as page option.
•
Set the SEG1, SEG7 as ON status and SEG13, SEG19 as OFF status.
‐
Set the each option separately since you cannot set the ADDRESS setting and indoor unit installation setting
option at the same time.
The procedure of setting option
Operation
Indication
Step 1
1
Remove the batteries from the remote controller.
2
Insert batteries while pressing
Button and
Button.
Step 2
1
Press
button to enter SEG2 value.
2
Press
button to enter SEG3 value.
Step 3
Press
button to be change to Cool mode in the ON status.
1
Press
button to enter SEG4 value.
2
Press
button to enter SEG5 value.
Summary of Contents for AJ NCJ2EG Series
Page 38: ......
