11
ENGLISH
Wiring & Assigning address
Room A
Room B
Outdoor
unit
Another EEV Kit
1.
Connect the AC power cable and communication cable from the outdoor unit to terminal, then connect the cable
to another EEV kit.
2.
Connect the AC power cable and communication cable to each indoor unit (A, B and C).
3.
EEV kit address should be set same with connected indoor units main address.
For example
:
When Main address is set as “03” that connected in pipe “A”, the EEV kit “A” address should be set as
“03”.
A
Function of Display
• The numbers which are displayed on left are the status of indoor unit
checking status through communication with same outdoor unit. (If it
indicates 1, 3 and 7, that means the ADDRESS of indoor unit is set to 1,
3 and 7.)
• The numbers which are displayed on right indicate the ADDRESS of
SW01/SW02,SW03/SW04 and SW05/SW06 in sequential. (If it indicates
0, 1 and 2, that means the SW01/SW02 is set to 0, the SW03/SW04 is
set to 1, and the SW05/SW06 is set to 2.)
• If the communication error occurs in EEV Kit, the Er
↔
C0 message will
be shown on the display alternatively.
Summary of Contents for AM FNCD Series
Page 40: ......
