Samsung AQT24A1QE/B, Service Manual

Samsung Electronics

3-4

3-2 Installation

3-2-1  Selecting Area for Installation 

Select an area for installation that is suitable
to the customer's needs.

3-2-1(a)  Indoor Unit

1 . Make sure that you install the indoor unit in

an area providing good ventilation.  It must
not be blocked by an obstacle affecting the

airflow near the air inlet and the air outlet.

2 . Make sure that you install the indoor unit in

an area allowing good air handling and
endurance of vibration of the indoor unit.

3.  Make sure that you install the indoor unit in

an area where there is no source of heat or
vapor nearby.

4 . Make sure that you install the indoor unit in

an area from which hot or cool air is spre a d
evenly in a ro o m .

5 . Make sure that you install the indoor unit in

an area away from TVs, audio units, cord-
less phones, fluorescent lighting fixture s
and  other electrical appliances (at least 1
m e t e r ) .

6 . Make sure that you install the indoor unit in

an area which provides easy pipe connec-
tion with the outdoor unit, and easy
drainage for condensed water.

7.  Make sure that you install the indoor unit in

an area which is large enough to accomo-
date the measurements shown in figure on
the next page.

3-2-1(b)  Outdoor Unit

1 . Make sure that you install the outdoor unit

in area not exposed to the rain or direct sun
l i g h t .

(Install a separate sunblind if exposed to

d i rect sun light.)

2 . Make sure that you install the outdoor unit

in area allowing good air moment, not
amplifying noise or vibration, especially to
avoid  disturbing neighbours.

(Fix the unit firmly if it is mounted in a

high place.)

3 . Make sure that you install the outdoor unit

in area providing good ventilation and
which is not dusty.  It must not be blocked
by any obstacle affecting the airflow near

the air inlet and the air outlet.

4 . Make sure that you install the outdoor unit

in area free from animals or plants.

5 . Make sure that you install the outdoor unit

in area not blocking the traff i c .

6.  Make sure that you install the outdoor unit

in area easy to drain condensed water fro m

the indoor unit.

7.  Make sure that you install the outdoor unit

in area which provides easy connection 

within the maximum allowable length of a
coolant pipe(10 meters).

N o t e

1. Add (18XX:20g, 24XX:30g) of re f r i g e r a n t
(R-22) for every 1 meter if the pipe length
exceeds the standard pipe length of 5 meters.
2. Maintain a height between the indoor and
outdoor units of less than 3 meters.

8 . Make sure that you install the outdoor unit

in an area which is large enough to accom-
modate the measurements 

shown in figure on the next page.

3-2-1(c)  Remote Control Unit

1 .

Make sure that you install the remote con-

t rol unit in an area free from obstacles such
as curtains etc, which may block signals
f rom the remote control unit.

2.  Make sure that you install the remote con-

t rol unit in an area not exposed to
d i rect sunlight, and where there is no sourc e
of heat.

3.  Make sure that you install the remote con-

t rol unit in an area away from TVs, audio
units, cordless phones, fluorescent lighting
f i x t u res and other electrical appliances (at
least 1 meter).

Caution :

It is harmful to the air conditioner if it is used in the following environments: greasy areas (including areas near machines),
salty areas such as coast areas, areas where sulfuric gas is present such as hot spring areas.  Contact your dealer for advice.