Installing the Remote Control Holder
The remote control is supplied with a plastic holder that can be fitted
to the wall to hold the remote control when it is not being used.
Choose a position where:
◆
The signal from the remote control will not be blocked (by
a curtain for example)
◆
The remote control is not exposed to direct sunlight or heat
◆
The remote control is at least one metre away from a television
or stereo system to avoid generating any parasites
To attach the holder to the wall, proceed as follows.
1
With a pencil, mark the positions of the two holes on the wall where the
holder is to be installed.
2
Drill the two holes and insert plugs as required for the type of wall on
which the holder is being installed.
3
Screw the holder into position.
Result:
The owner can now slide the remote control in and out
of the holder as required.
Explaining Operations to the Owner
Before leaving the premises on which you have installed the air conditioner,
you should explain the following operations to the owner, making
reference to the appropriate pages in the owner’s instruction booklet.
1
How to start and stop the air conditioner.
2
How to select the operating mode and adjust the temperature and fan set-
tings.
3
How to adjust the air flow direction.
4
How to set the timers.
5
How to remove and clean the filters.
Once the owner is happy with the basic operations, hand over the owner’s instruc-
tion booklet and this installation manual for storage in a handy and safe place.
OWNER'S
INSTRUCTIO
NS
SPLIT-TYPE R
OOM AIR CON
DITIONER
E-
41
C
OMPLETING THE
I
NSTALLATION
AS12A1VC-E 1/26/00 3:16 PM Page 19
