94
Chapter 4.
Settings and Upgrade
Setting a Boot Password
3
Enter a password, press <
Enter
>, re-enter the password for
confirmation, and press <
Enter
> again.
The password can be up to 8 alphanumeric characters.
Special characters are not allowed.
4
The supervisor password has been set.
The supervisor password is required to turn the computer on
or to enter the BIOS Setup.
For some models, if the password entered message appears
in the
Setup Notice
window, the settings are not complete
until the <
Enter
>
key is pressed.
Setting a User Password
Using the User Password, you can turn the computer on but you
cannot change the major settings of the BIOS Setup because you
cannot enter the BIOS Setup.
This helps prevent unauthorized access to the major settings in
the BIOS Setup menu.
Before configuring a user password, a
supervisor password
must
have been configured. Deactivating the supervisor password also
deactivates the user password.
In the
Set User Password
item, press <
Enter
> and complete the
procedures from Step 3 of Setting a Supervisor Password.
Setting Up a Boot Password
To setup a boot password, the administrator password (
Set
Supervisor Password
) should be set in advance.
Set the
Password on boot
item to
Enabled
.
Once a boot password is set, you have to enter a password to boot
up the computer.
Be sure to remember the password for later use.
Summary of Contents for ATIV Tab 7
Page 1: ...User Guide ...
