English_2
●
C
A
me
RA
Ope
RATION
DURATION : This function is used to select the brightness of light where
switching occurs.
GAIN LEVEL
LOW
MID
HIGH
Color
→
B/W B/W
→
Color Color
→
B/W B/W
→
Color Color
→
B/W B/W
→
Color
VERY SLOW
2.4
5.2
1.5
5.6
0.6
6.2
SLOW
2.5
5
1.8
5.4
1.1
6
NORMAL
2.6
4.9
2.1
5.2
1.6
5.8
FAST
2.7
4.8
2.4
5
2.1
5.4
VERY FAST
2.8
4.7
2.7
4.8
2.6
5
※
Depending on the installation environment and the exposure menu’s gain
mode setting, the switching brightness may vary.
DWELL TIME : You can select day/night switching delay time from.
→
3s, 5s, 7s, 10s, 15s, 20s, 30s, 40s, 60s
If you set the AGC mode to off on the exposure menu, you cannot switch the day/night mode to auto.
When a bright light source is in the screen or there are frequent brightness changes, if you use the
auto night/day mode, and set the switching time to short (3, 5 sec), a hunting can be caused. In this
situation, it is recommended to use the default setting (30 sec).
EXTERN : Ground to the grounding terminal to allow automatic switching between
COLOR and B/W (Black/White).
COLOR : The picture is always displayed in color.
B/W : The picture is always displayed in black and white.
You can turn on or off the burst signal on B/W mode.
If the lens mounted in the camera is different from the one set in <LENS> of the
<EXPOSURE> menu, then the night/day mode may not operate normally.
DEfog :
You can use the defog mode to allow the camera to automatically
detect the fog density of the screen and display a clear image despite
smog, fog or general poor visibility.
❶
If the SPECIAL menu screen is displayed, use the Function Setup switch so that
the arrow indicates ‘DEFOG’.
❷
Select a desired mode using the Function Setup switch.
AUTO : Adjust the level automatically.
Manual : Depending on the defog
level set by the user,
adjust the clarity of image.
(LOW, MIDDLE, HIGH)
OFF : Released state
M
-
-
-
M
-
-
-
DEFOG MANUAL SETUP
▶
1.
LEVEL
MIDDLE
2.
RETURN
