C
OMMANDS
ESC c 3
n
[Name]
Select paper detector(s)to output paper end signals
[Format]
ASCII ESC c 3
n
Hex 1B 63 33
n
Decimal
27
99
51
n
[Range]
0
≤
n
≤
255
[Description]
Selects paper detector(s) to output paper end signals, using n as
follows:
Bit
Off/On
Hex
Decimal
Function
Off
00
0
Paper roll near end sensor disabled.
0
On
01
1
Paper roll near end sensor enabled.
Off
00
0
Paper roll near end sensor disabled.
1
On
02
2
Paper roll near end sensor enabled.
Off
00
0
Paper roll end detector disabled.
2
On
04
4
Paper roll end detector enabled.
Off
00
0
Paper roll end detector disabled.
3
On
08
8
Paper roll end detector enable.
4 - - - Undefined
5 - - - Undefined
6 - - - Undefined
7 - - - Undefined
[Notes]
▪
It is possible to select multiple detectors to output signals. Then, if
any of the detectors detects a paper end, the paper end signal is
output.
▪
Detectors are switched when executing this command. Because of
this, the paper-out signal switching may delay depending on the
receive buffer state.
[Default]
n
= 15
2002. 1. 8.
Programmer’s Guide
35
