6
.3
<Faxing (Optional)>
the right side of the screen, if you have stored frequently used fax
numbers.
6
To add a number, press
Add No
.
7
Press
Start
on the control panel. The machine starts to scan and
send a fax to destinations.
Sending a fax manually (On Hook Dial)
1
Press
Fax
from the
Main
screen.
2
Place the originals face up into the DADF.
3
Adjust the document settings in the
Image
tab.
4
Select
Duplex
and
Resolution
options in the
Basic
tab.
5
Press
On Hook Dial
on the control panel.
6
Enter a fax number using the number keypad on the control panel.
If the number is which you have dialed recently, press the
Redial/
Pause
button on the control panel to show ten recent fax numbers
and select a fax number.
7
Press
Start
when you hear a high-pitched fax signal from the
remote fax machine.
Note
• When you want to cancel a fax job, press
Stop
before the
machine start transmission. Or press the
Job Status
button,
and select the job you want to delete, press
Delete
.
• If you used the scanner glass, the machine shows the
message asking to place another page.
• While the machine is sending a fax, you can not send an email
at the same time. (Page 7.4)
Note
Color faxes are only supported when faxes are sent manually.
(Page 6.6)
Automatic resending
When the number you have dialed is busy or there is no answer, the
machine automatically redials the number.
To change the time interval between redials and/or the number of redial
attempts, refer to the next following steps.
1
Press
Machine Setup
on the control panel.
2
Select
Admin Setting
. When the login message pops up, then
enter password and press
OK
. (Page 3.5)
3
Press the
Setup
tab >
Fax Setup
.
4
Press
Redial
.
5
Select
Redial Term
and
Redial Times
.
6
Press
OK
.
Redialing the last number
1
Press
Fax
from the
Main
screen.
2
Adjust the document settings in the
Image
tab.
3
Place the originals face up into the DADF.
4
Press the
Redial/Pause
button on the control panel to show ten
recent fax numbers.
5
Select a fax number in the list and press
OK
.
The machine automatically begins to send.
Delaying a fax transmission
You can set your machine to send a fax at a later time when you will not
be present.
1
Press
Fax
from the
Main
screen.
2
Place the originals face up in the DADF.
3
Adjust the document settings in the
Image
tab and the
Basic
tab.
4
Press the
Advanced
tab >
Delay Send
.
Summary of Contents for CLX-8380ND
Page 1: ......
Page 137: ...Samsung Printer Software section...
Page 141: ...4 Scanning 47 Scanning with USB 47 Scanning with network 47...
Page 187: ...Ver 5 00...