33
Reading each Memory Program’s Cycle Counter
1.
Clear all operations by pressing the
Stop/ Cancel
button.
Press the
Check
button to enter Check mode.
2.
Press the
Start
button, and then press any
Number
button, from 1 to 20, and the number of cycles for that
particular Memory Program will be displayed. The cycle
count is displayed in units of 10.
Fox example, if Memory Program 5 has been used
100 times, the display will show ’10’.
As the display uses units of 10, the cycle counts are approximate. The cycle count
displayed increases every ten cycles.
For example, if the cycle count were 90-99, “9” would be displayed. The “9” would
change to “10” on the 100
th
cycle. The cycle counter function has a limit of 99,999
cycles. Once that number is exceed, the cycle counter will automatically clear and
start again from “0”.
3.
After one second, the display will clear
automatically. If you want to check other Memory
Programs, just enter the Memory Program numbers.
4.
Press the
Stop/Cancel
button to exit the Checking mode.
