- 9 -
3-3 Operation Guide (Continued)
Multi-stage
1. Hold down PROGRAM LOCK( ) and then press PROGRAM( ) pad. Hold together
for 2 sec.
* Be sure to press the pads firmly.
Result
: PROG indicator appears in the digital display.
2. Press appropriate NUMBER pad for the desired memory number.
Result
: Selected memory program code appears below the PROGRAM indicator.
3. Select power level by pressing the POWER LEVEL pad or DEFROST pad.
* Press the POWER LEVEL pad and DEFROST pad one or more times until you get
the desired power level.
4. Press NUMBER pads to set the cooking time.
* The maximum time according to each cooking power level can be referred to in the
title “Power Levels and Time Variations” on page 6. The NUMBER pads will not oper-
ate or respond when you press a cooking time exceeding the maximum value. It is
not possible to set a cooking time for longer than the maximum time allowed on the
chosen program. It is advisable to press CANCEL and to enter a new power level
and cooking time.
5. Repeat steps 3 and 4 for II or III stage memory programming.
6. Hold down PROGRAM LOCK( ) and then press PROGRAM( ) pad. Hold together
for 2 sec once again.
Result
: PROG indicator and memory number indicator blink 3 times in the digital
display with a beep sound. And then the display goes blank.
Caution
: Be sure to press the pads firmly in the right position.
7. When you want to program more, repeat the procedures above again.
* Memory programs are available up to 30 items.
Make sure the unit is properly programmed.
After programming is finished, all you have to do for memory cooking is to press the
NUMBER pad. Then the selected memory program automatically starts cooking.
→ You can not set up the same POWER LEVEL or DEFROST.
→ It operates as setting up sequence.
