Samsung CN15MO series, Service Manual

3-1-1 Removing the Stand

1. Remove 4 screws in the hinge area.
2. Pry it off the back of the monitor.
3. Disconnect Power Cord and Signal Cable.

3-1-2 Main Body Disassembly

1. Remove the 4 screws on the four corner of the

Rear Cover.

2. Remove Rear Cover from the Front Cover.
3. Remove 11 screws on the Shield and remove

the shield. 

4. Disconnect Inverter wire, Function PCB wire

and Interface wire.
Remove 4 screws on the Main PCB and
remove 2 screws on the D sub shield.

5. Remove the Main PCB Assembly.
6. Remove 6 screws on the Inverter PCB

Assembly and then remove it

7. Remove 6 screws on the Rear Panel Bracket. 
8. Remove the Bracket Assembly from the Front

Cover.

9. Remove 3 screws on the Function PCB from

locking area of Function knob and remove
Function PCB.

10. Remove 4 screws on the Shield of Panel.
11. Remove the Shield.
12. Remove Rear Bracket from Panel.
13. Remove 2 screws between Panel Rear and

Inverter PCB.

14. Remove the Interface wire on the Rear Side of

Panel.

3-1-3 Standard Stand Disassembly

1. Remove 5 screws from the Stand Rear
2. Remove 4 screws from the Stand Bottom.

3. Remove Stand Front from the Stand assembly.
4. Remove 2 screws from the Stand assembly.
5. Remove the Stand Rear from the Stand

assembly.

6. Remove 5 screws on the Vesa Brkt from the

Stand assembly.

7. Remove cover hinge from the Stand assembly.
8. Remove Stand Base from the Stand assembly.

3-1-4 Pivot Multi-media Stand Disassembly

(option)

1. Stand the stand assembly with the base close

to you.

2. Remove the 4 screws on the back cover of the

stand and remove it.

3. Stand the stand assembly upside down.
4. Remove the 4 screws.
5. Disconnect CN805, CN806, CN807, CN808,

CN809, CN812 and F1.

6. Remove the Back Cover of the Stand Front

assembly.

7. Remove 4 screws on the external adaptor and

remove the adaptor.

8. Remove 2 screws between hinge and Stand

Body.

9. Remove the hinge
10. Remove 2 screws on Audio main PCB and

remove it

11. Remove 2 screws on the Audio Function PCB

and remove it.

3-1-5 Angle Pivot Stand Disassembly (option)

1. Remove the cap pivot from the stand

assembly.

2. Remove the 4 screws on the hinge assembly.
3. Remove the 4 screws on the Stand Rear

SyncMaster 570B TFT / 580B TFT

3-1

3 Disassembly and Reassembly

This section of the service manual describes the disassembly and reassembly procedures for the
Sync Master 570B TFT / 580B TFT monitors.

WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling

these components.

3-1 Disassembly

Cautions:1. Disconnect the monitor from the power source before disassembly.

2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.