installing the hob _
Ins
Tall
In
G
T
he hob
installing the hob
Important
:
Be sure the new appliance is installed and grounded only by qualified personnel.
Please observe this instruction. The warranty will not cover any damage that may
occur as a result of improper installation.
Technical data is provided at the end of this manual.
reGulaTIons and ComplIanCe
This appliance meets the following standards:
•
EN 60335 - 1 and EN 60335 - 2 - 6, relating to the safety of electrical appliances for
household use and similar purposes;
•
EN 60350, or DIN 44546 / 44547 / 44548, relating to the operating features of electric
cookers, hobs, ovens, and grills for household use;
•
EN 55014-1
•
EN 55014-2
•
EN 61000 - 3 - 2; and
•
EN 61000 - 3 - 3, relating to basic requirements for electromagnetic compatibility (EMC).
This appliance complies with the following EU Directives:
• 2006/95/EC, Low Voltage Directive
• 2004/108/EEC, Electromagnetic Compatibility Directive
safeTy InsTruCTIons for The InsTaller
•
A device must be provided in the electrical installation that allows the appliance to be
disconnected from the mains at all poles with a contact opening width of at least 3 mm.
Suitable isolation devices include line protecting cut - outs, fuses (screw type fuses are to
be removed from the holder), earth leakage trips and contactors.
•
With respect to fire protection, this appliance corresponds to EN 60335 - 2 - 6. This type
of appliance may be installed with a high cupboard or wall on one side.
•
Drawers may not be fitted underneath the hob.
•
The installation must guarantee shock protection.
•
The kitchen unit in which the appliance is fitted must satisfy the stability requirements of
DIN 68930.
•
For protection against moisture, all cut surfaces are to be sealed with a suitable sealant.
•
On tiled work surfaces, the joints in the area where the hob sits must be completely filled
with grout.
•
On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in
place with a suitable artificial resin or mixed adhesive.
•
Ensure that the seal is correctly seated against the work surface without any gaps.
Additional silicon sealant must not be applied; this would make removal more difficult
when servicing.
•
The hob must be pressed out from below when removed.
•
A board is to be installed underneath the hob.
•
The ventilation gap between the worktop and front of the unit underneath it must not be
covered.
CTI613GI series_EN-00205A_XSA.in7 7
2009-02-25 10:10:29
