20_
operating
Removing any residual matter inside
the water supply line after installing
the water fi lter.
1.
Turn ON the main water supply
and supply water from water
supply line.
2.
Run water through the
dispenser until the water runs
clear (approx. 6 to 7 minutes).
This will clean the water supply system and
remove air from the lines.
3.
Additional flushing may be required in some
households.
4.
Open the Refrigerator door and make sure there
are no water leaks coming from the water filter.
Be sure to fl ush the dispenser thoroughly,
otherwise water may drip from the dispenser.
This means that there is still air in the line.
Reverse Osmosis Water Supply
IMPORTANT
: The pressure of the water supply
coming out of a reverse osmosis system going to
the water inlet valve of the refrigerator needs to be
between 35 and 120 psi (241 and 827 kPa).
If a reverse osmosis water fi ltration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to be
a minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis system
is less than 40 to 60 psi (276 to 414 kPa):
•
Check to see whether the sediment filter in the
reverse osmosis system is blocked. Replace the
filter if necessary.
•
Allow the storage tank on the reverse osmosis
system to refill after heavy usage.
•
If your refrigerator has a water filter, it may
further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water filter.
If you have questions about your water pressure, call
a licensed, qualifi ed plumber.
•
When you pull the water filter, a little water can
leak from the opening. This is normal. To minimize
the water leaks, keep the filter cartridge horizontal
when you pull it.
•
To prevent overflow, empty the water tray filter (
3
)
and dry around of case filter (
2
).
3.
Insert the new filter into the filter case (
4
)
4.
Push the filter, and then turn it clockwise until it
locks.
3
2
•
If you are in trouble of inserting the water
filter as high pressure of water, shut off the
water supply valve.
•
The locked symbol should be lined up with the
indicator line.
4
5.
press the “
Alarm/hold 3
sec for Filter Reset
” button
(
(Filter Reset)
(Filter Reset)
) for about 3
seconds to reset the water
filter. The color of indicator (
) changes from red to light
off.
6.
If you turned off the water supply, turn it back on.
For a replacement water fi lter, you can visit
your local home Improvement center or
contact the Samsung Parts distributor.
Be sure the replacement water fi lter has the
SAMSUNG logo on the box and on the water
fi lter.
DA99-03404D-11.indb 20
DA99-03404D-11.indb 20
2015. 5. 7.
8:10
2015. 5. 7.
8:10
