DCB-B263Z
GB-19
GB
DCB-B263Z
GB-18
D
I
G
I
T
A
L
C
A
B
L
E
R
E
C
E
I
V
E
R
OPERATING THE RECEIVER
OPERATING THE RECEIVER
1. Installation
This menu consists of 4 sub-menus:
Scan and Reset to Factory Defaults.
●
Select “
Installation
” in the main menu mode to
select the sub menu.
●
Enter the
PIN
Code.
If you have not entered your own
PIN
Code then the
PIN
Code
0000
applies, which was set at the factory.
1.1 Auto scan
The sub menu “
Auto scanning
” will enable download the
channels automatically with network ID.
●
Input the Network ID of the channel you want to fid.
Ask your cable operator or refer to the card information.
●
After input the Network ID, press
OK
key to start the scan
process.
1.2 Linear scan
When do not know Network ID, use this function.
The sub menu “
Linear scanning
” will enable download the
channels automatically.
To download channel automatically:
●
Press
OK
key.
Auto scanning menu will be displayed.
You should press
OK
key to store all channels into STB.
1.3 Manual scan
To tune-in new channels and weak signals, the STB has been
provided with “
Manual scanning
” where the channel data
can be entered by the user. After selecting the “
Manual
scanning
” from the Installation Menu, the following screen will
be displayed:
●
Input the frequency of the Channel you want to find.
●
Input the symbol rate of Channel you want to find.
●
Select the Modulation of the Channel you want to find.
You can select the value of 16, 32, 64, 128, 256 QAM, or
Automatic.
●
After select option, press
OK
key to start the scan process.
1.4 Reset to Factory Defaults
This to restore the factory set values in case the user has
encountered some problems after changing any values
of channel data and others which may be in error.
At the request window, if you press the
OK
key, the receiver
will be reset to factory default settings automatically.
N
No
otte
e
:
This cause your previous settings to be deleted!
MF68-00411A_GB 1/23/07 7:38 PM Page 18
