DCB-B263Z
GB-28
DCB-B263Z
GB-29
D
I
G
I
T
A
L
C
A
B
L
E
R
E
C
E
I
V
E
R
GB
OPERATING THE RECEIVER
4.5 System Information
If you have to contact your service provider or a service center
they might ask for information available from this menu.
Place the cursor on this sub menu and press the
OK
key.
The following will be the on-screen display.
●
Press
YELLOW (ALT)
key for help.
4.6 Software Upgrade
You can download and upgrade the system software of the receiver through a specific channel
through a specific channel designated by the broadcaster.
The distributor will provide you with more information about that.
If you select to download a new software version, all your previous settings, access code and
favourite channels etc. will be erased! Downloading may take a while. During downloading, don’t
turn off the receiver.
●
Press
YELLOW (ALT)
key for help.
5. Embedded Conax
When you insert the card supplied from Conax, you can see
the program for Conax.
TROUBLESHOOTING
Problem
Possible cause
Solution of the problem
No display LED on
Power cord
Power cord plug in correctly
the front panel;
not plugged in correctly
No power supply
No pictures on the screen
Receiver in Standby mode;
Set receiver to “On”;
SCART not connected tightly
Check connection and correct;
to video output of television;
incorrect channel or video
Check channel and video output and
output selected on television
correct (TV instruction manual)
No sound
Audio cord connected
Check connection and correct;
incorrectly;
Volume level = 0;
Increase volume on television set;
Muting active
Press the MUTE key
Remote Control does not
Batteries dead or inserted
Point remote control towards the
operate directly
incorrectly
Receiver.
Replace batteries or insert correctly
Poor picture quality
Signal strength too low
Check the signal strength in
the “Installation” menu, correct
alignment of your signal cable
On-Screen Error Message
Antenna cable not connected
Check connection and correct;
“Searching for signal”
or not tight;
incorrect position of the
Check position and correct,
signal;
Check the signal strength in
the “Installation” menu
On-Screen Error Message
Receiver not yet set
Scanning of in “Installation” menu
“Channel data does not
exist.”
On-Screen Error Messages: Smartcard:
(depend on model)
“Please check the - not plugged in correctly; Check the Smartcard.
Smartcard”; - not plugged in. “Insert the Smartcard.”
“Please insert the
Smartcard”.
On-Screen Error Messages: No access to this channel
Check that you subscribe to this channel.
“No access”
If the STB has been switched off for a
longer period of time, turn on the STB,
select any channel, and wait for
authorization for up to 60 minutes.
The device, packaging material (e.g. Styrofoam) and the batteries must never be
disposed of with household refuse.
Please obtain appropriate information about the regulations in your community, and
dispose of all refuse in accordance with regulations at the separate locations provided.
DISPOSAL
MF68-00411A_GB 1/23/07 7:38 PM Page 28
