Page 41
3.42 PROGRAMMING FEATURE KEYS
Allows the System Administrator to customise the programmable keys on specific keysets on the DCS
system. Buttons 1 and 2 are set as CALL buttons by default. Features are entered via the dial pad key
by pressing the dial pad number the required steps to select the feature. For example, for OHVA the
number 6 is pressed three times. If a BOSS key is required, press 2 for the first letter B, and then use the
UP or DOWN key to change selection from BARGE to BOSS.
DIAL KEYPAD
COUNT
→
1
2
3
4
DIAL 2
AAPLAY
BARGE
CALL
DIAL 3
DICT
DICT
FAUTO
DIAL 4
GPIK
HLDPK*
IG
DIAL 5
LCR
LCR
LCR
DIAL 6
MMPA
NEW
OHVA
DIAL 7
PAGE
PAGE
REJECT SETMG
DIAL 8
TG
UA
VDIAL
* On the DCS 70 this is HDSET
PROGRAM KEYS
UP & DOWN
Used to scroll through options
KEYPAD
Used to enter selections
SOFT KEYS
Move cursor left and right
SPEAKER
Used to store data and advance to next program
HOLD
Used to clear previous entry
ACTION
DISPLAY
1. Press
TRSF
722
[201] KEY PROG.
Display shows
01 : CALL 1
→
2. Enter selected station number (eg.,
205
)
[205] KEY PROG.
OR press
UP
or
DOWN
key to select
01 : CALL 1
→
station number and press RIGHT soft key
to move cursor
3. Enter selected key number (eg., 18) OR
[205] KEY PROG.
press
UP
or
DOWN
key to select key
18 : NONE
→
_
number and press the RIGHT soft key to
move the cursor
4. Using above chart press the dial pad key
[201] KEY PROG.
number to make selection OR press the
18 : NONE
→
GPIK_
UP
or
DOWN
key to make selection
and press RIGHT soft key to move
the cursor to step 5 to enter extender
if required or to return to step 2
5. If required, enter extender (eg.,
03
) OR
[201] KEY PROG.
Press
UP
or
DOWN
key to make
18 : NONE
→
GPIK 03
selection Press RIGHT soft key to
return to step 2