using the detergent and water softener
_15
LOADING THE SALT INTO THE SOFTENER
Always use salt intended for use with dishwasher.
The salt container is located beneath the lower rack and should be fi lled as follows:
ATTENTION
• Only use s alt specifi cally designed for use in dishwashers! All other types of salt not specifi cally
designed for use in a dishwasher, e specially table salt, will damage the water softener. In case of
damages caused by the use of unsuitable salt the manufacturer does not give any warranty nor is
liable for any caused damages.
• Only fi ll with salt just before starting one of the complete washing programmes. This will prevent
any grains of salt or salty water, which may have been split, remaining of the bottom of the
machine for any period of time, which may cause corrosion.
• After the fi rst wash cycle the control panel light expires.
1.
Remove the lower basket and then unscrew and remove the cap from
the salt container.
2.
If you are fi lling the container for the fi rst time, fi ll 2/3 of its volume with water (around 500 ml).
3.
Place the end of the funnel (supplied) into the hole and introduce
about 1,2 kg of salt. It is Normal for a small amount of water to come
out of the salt container.
4.
Carefully screw the cap back on.
5.
Usually, the salt warning light will be off in 2-6 after the salt container days be fi lled with salt.
• The salt container must be refi lled when the salt warning light in the control panel comes on.
Though the salt container is fi lled enough, the indicator light may not black out before the salt fully
dissolve.
If there is no salt warning light in the control panel, you can judge when to load the salt into the
softener by the cycles that the dishwasher had run (see the following schema ).
• If there are spills of the salt, a pre-wash option should be run to wipe them out.
03 using the detergent and water softener
Open
Open
DD81-01306A-01_EN.indd Sec5:15
DD81-01306A-01_EN.indd Sec5:15
2012-09-27 10:53:03
2012-09-27 10:53:03
