installing the dishwasher
_9
02 I
NST
A
ll
ING
T
he d
IS
h
W
AS
her
STEp 3
WATer SUPPly reqUIreMeNTS
•
The hot water supply line pressure must be between 20~120 psi (140~830 kPa).
•
Adjust the water heater to deliver water between 120 ˚F(49 ˚C)~ 149 ˚F (65 ˚C).
1.
The dishwasher must be connected to a hot water supply between 120 ˚F(49 ˚C)~ 149 ˚F
(65 ˚C). This temperature range provides the best washing result and shortest cycle time.
Temperature should not exceed 149 ˚F (65 ˚C), to prevent damage to dishes.
2.
Ensure that the water supply valve is turned off before connecting the water supply line to the
dishwasher.
3.
Seal the water supply line connections using teflon tape or sealing compound to stop any
water leakage.
4.
The water supply line should be placed in the channels at the base of the dishwasher as
shown in Figure 2. Do not place the dishwasher on the water supply line.
5.
The drain hose connected to the dishwasher must be run through the hole in the side wall so
it can be connected to the drain outlet of the sink. Ensure that there is nothing on the drain
hose and be careful not to tear it during the installation process.
<Figure 2>
Water supply
line
power cable
5¹⁄
3
~7¹⁄
3
in.
(135 ~ 185mm)
installation_DD68-00046A-03_EN.indd 9
2010-10-19 �� 2:24:57
