36
Setting temperature control of discharge air
1. Use of “Temperature control of discharge air” or target temperature of discharge air in cooling/heating can be set with the
service mode of a wired remote controller. (Refer to the installation manual of a wired remote controller.)
2. When using temperature control of discharge air, thermo on/off of Indoor unit is decided by set room temperature and
room temperature, and the temperature of discharge air is adjusted to meet the target temperature of discharge air in
thermostat On section.
3. When using temperature control of discharge air, the temperature of discharge air cannot always be adjusted to the
target temperature due to external conditions or protective control of the outdoor unit.
❋
Temperature control of discharge air can be set with DMS as well.
Final Checks and User Tips
To complete the installation, perform the following checks and tests to ensure that the air conditioner operates correctly.
1. Check the followings.
f
Strength of the installation site
f
Tightness of pipe connection to detect a gas leak
f
Electric wiring connections
f
Heat-resistant insulation of the pipe
f
Drainage
f
Earth conductor connection
f
Correct operation (follow the steps below)
After finishing the installation of the air conditioner, you should explain the following to the user. Refer to appropriate pages
in the User’s Manual.
1. How to start and stop the air conditioner
2. How to select the modes and functions
3. How to adjust the temperature and fan speed
4. How to adjust the airflow direction
5. How to set the timers
6. How to clean and replace the filters
• When you complete the installation successfully, hand over the User’s Manual and this Installation Manual to the
user for storage in a handy and safe place.
NOTE
Summary of Contents for Duct Type Series
Page 40: ...DB68 03807A 04...
