operating instructions, tips
_25
Select Cycle
Option
Adjust Time
– You can add or subtract time from the automatically set times
in the Wrinkle Release cycle and the Manual Dry cycles (Time Dry, Quick Dry,
or Air Fluff cycles.)
To add or subtract time from the cycle, press the Adjust Time arrow pad up or
down until the desired time is displayed.
Wrinkle Prevent
-Wrinkle Prevent provides approximately 180 minutes
of intermittent tumbling in unheated air at the end of the cycle to reduce
wrinkling. Press the Wrinkle Prevent button to activate this feature.
The indicator light above the pad will illuminate when you select Wrinkle Prevent.
The load is dry and you can remove it at any time during the Wrinkle Prevent cycle.
Mixed Load Bell (DV456*)
- This is an alarm that notifies you when the
average dry level of a mixed load with various types of cloth is damp dry
(80 % dried). When this level is reached, an alarm sounds for five (5) seconds.
After the alarm sounds, the dryer will continue to run until you turn it off or the
clothes reach the level of dryness you selected at the start of the cycle.
This function can only be selected in the Sensor Dry course, and the dry level
can only be selected from among Normal Dry, More Dry, and Very Dry.
Smart Care (DV456*)
- Use this function to check if the Dryer is out of order
using your smart phone when the Dryer malfunctions. This function is set if
you press and hold the Mixed Load Bell key for 3 seconds within 10 seconds
of turning the power on or when an error occurs.
Start/Pause
selection button
Press to pause and restart programs.
My Cycle button
Choose your favorite cycle including cycle, temp, dry level option, etc. (See
page 27 for detail.)
Power button
Press once to turn your dryer on, press again to turn it off. If you turn
your dryer on and do not touch any buttons for 10 minutes, the power
automatically turns off.
02 operating instructions, tips
9
8
7
6
DV400-03170A_EN_HUDSON-PJT_v1.indd Sec6:25
DV400-03170A_EN_HUDSON-PJT_v1.indd Sec6:25
2012-01-20 1:58:32
2012-01-20 1:58:32
