English - 15
DRAINING WATER WITHOUT USING THE WATER TANK
You can use the dryer without using the water tank by following the procedures below.
CONNECTING THE DRAIN HOSE
The Dryer can pump the condensed water outside of the DRYER directly
with drain hose provided.
The procedures to connect the drain hose are as follows.
1.
Disconnect the drain hose
A
.
2.
Connect the drain hose
A
to the other part.
3.
Connect accessory hose (long drain hose)
B
to the hole
next to the part that is connected to drain hose
A
.
•
Because the dryer’s drain pump can only pump up
the drain water to 90 cm height, when you connect
the drain hose
B
to the drain point, make sure that
the height of drain point does not exceed 90 cm.
A drainage error may occur if the drain point exceeds
90 cm. If a drainage error occurs, the control panel displays an error code.
•
After connecting the drain hose, you can directly drain the condensed water via the
drain-outlet through the connected drain hose or through the washstand or the drain-
outlet of the washstand.
CAUTION
INST
ALLING YOUR DR
YER
A
A
B
DV80H4000CX-03408E-03_EN.indd Sec3:15
DV80H4000CX-03408E-03_EN.indd Sec3:15
2014-11-28 2:41:20
2014-11-28 2:41:20
Summary of Contents for DV80H4100CW
Page 38: ...English 38 note ...
Page 39: ...note ...