14
GB
Tuning Your Television for the DVD-VCR
2
4
You must tune your television for the DVD-VCR only if you are
not using a Scart cable
➢
To view pictures from your DVD-VCR when a Scart
cable is used, the television must be set to the
audio/video mode (AV).
1
Switch on the television.
2
Switch on the DVD-VCR by pressing STANDBY/ON on the front
of the DVD-VCR or STANDBY/ON on the remote control.
3
Select a programme position on the television to be reserved for
use with your DVD-VCR.
4
Insert the video cassette in the DVD-VCR. Check that the
DVD-VCR starts reading the cassette; if not, press
❿
II
button.
5
Start a scan on your television or set the television to UHF
channel 36.
6
Fine tune the television until the pictures and sound are obtained
clearly.
7
If you cannot find the pictures and sound, or there is interference
from nearby channels, it may be necessary to change the setting
of the DVD-VCR output channel (see Setting the DVD-VCR
Output Channel on page 23 and Problems and Solutions on
page 72).
8
When the picture and sound are perfectly clear, store this
channel at the desired programme position on the television.
Result:
That programme is now reserved for use with your
DVD-VCR.
00451A DVD- CM250/EUR-GB1 5/18/04 4:16 PM Page 14
