GB
15
GB
14
Tuning Your Television for the DVD-VCR
You must tune your television for the DVD-VCR only if you are not
using a Scart cable
➢
To view pictures from your DVD-VCR when a Scart cable
is used, the television must be set to the audio/video
mode (AV).
1
Switch on the television.
2
Switch on the DVD-VCR by pressing STANDBY/ON on the front of
the DVD-VCR or STANDBY/ON on the remote control.
3
Select a programme position on the television to be reserved for
use with your DVD-VCR.
4
Insert the video cassette in the DVD-VCR. Check that the
DVD-VCR starts reading the cassette; if not, press
❿
II
button.
5
Start a scan on your television or set the television to UHF
channel 60.
6
Fine tune the television until the pictures and sound are obtained
clearly.
7
If you cannot find the pictures and sound, or there is interference
from nearby channels, it may be necessary to change the setting
of the DVD-VCR output channel (see Setting the DVD-VCR
Output Channel on page 25 and Problems and Solutions on page
77).
8
When the picture and sound are perfectly clear, store this channel
at the desired programme position on the television.
Result:
That programme is now reserved for use with your
DVD-VCR.
4
2
You can connect your DVD-VCR to a Hi-Fi system.
Example: You wish to take advantage of the quality of your Hi-Fi
stereo system when watching a programme or recording
via your DVD-VCR.
☛
◆
Regardless of the type of connection chosen, you
must always connect the coaxial cable supplied.
Otherwise, no picture will be visible on the screen
when the DVD-VCR is switched off.
◆
Make sure that both the television and the DVD-VCR
are switched off before connecting the cables.
1
Connect the coaxial cable or SCART as indicated on page 13.
2
Plug the audio output cable into the audio connectors on the rear
of your DVD-VCR.
➢
Respect the colour coding of the left and right channels.
3
Plug the other end of the audio cable into the appropriate input
connectors on your Hi-Fi stereo system.
Connecting the Audio Output Cable
2
2
1
Plug & Auto Set up
Your DVD-VCR will automatically set itself up when it is plugged
into the mains for the first time. TV stations will be stored in
memory. The process takes a few minutes. Your DVD-VCR will
then be ready for use.
1
Connect the coaxial cable as indicated on page 12.
(Connecting Your DVD-VCR to the TV Using the Coaxial Cable)
2
Plug the DVD-VCR into the mains.
3
Start the auto scanning.
◆
The number of stations automatically stored by the DVD-VCR
depends on the number of stations that it has found.
4
The current time and date are displayed automatically.
Check the date and time.
if it is :
◆
Correct, Press RETURN button twice to exit the menu.
◆
incorrect, see page 19.
➢
Auto preset can be performed by pressing
■
(STOP) on
the VCR continuously for 5 seconds or more with no
tape inserted.
2
AUTO SET UP
PLEASE WAIT
60
%
I
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
-------I
RETURN
TV
RETURN
➛❿
❷
CLOCK SET
12:01 1/JAN/2003
WED
AUTO CLOCK : ON
