15
14
Deck Control Keys
The DVD-VCR uses one set of controls to operate both decks. The
following keys are helpful in successfully controlling each deck.
1
待机(STANDBY/ON)
Button
Press the
待机(STANDBY/ON)
button on the remote control or the
待机(STANDBY/ON)
button on the front panel to turn on the DVD-
VCR.
2
DVD Button
Press the DVD button on the remote control when you want to
control the DVD deck.
◆
The DVD indicator will light on the Front Panel Display to show
that the DVD deck is selected.
3
VCR Button
Press the VCR button on remote control when you want to control
the VCR deck.
◆
The VCR indicator will light on the Front Panel Display to show
that VHS deck is selected.
4
输入选择(INPUT SEL.)
BUTTON
Press the
输入选择(INPUT SEL.)
button repeatedly to cycle
through all of your input sources, including the Tuner (PR##), Line
(rear AV input).
• Input select is only available when the VCR deck is selected.
➢
Before using the VCR operation of 18~42 pages, press
the VCR button on the remote control to select VCR
mode.
Before using the DVD operation of 43~65 pages, press
the DVD button on the remote control to select and
watch DVD.
1
1
2
3
4
Tuning Your Television for the DVD-VCR
2
4
You must tune your television for the DVD-VCR only if you are not
using a RCA cable
➢
To view pictures from your DVD-VCR when a RCA cable
is used, the television must be set to the audio/video
mode (AV).
1
Switch on the television.
2
Switch on the DVD-VCR by pressing
待机(STANDBY/ON)
on the
front of the DVD-VCR or
待机( S T A N D B Y / O N
) on the remote
control.
3
Select a programme position on the television to be reserved for
use with your DVD-VCR.
4
Insert the video cassette in the DVD-VCR. Check that the
DVD-VCR starts reading the cassette; if not, press
II
button.
5
Start a scan on your television or set the television to UHF
channel 38.
6
Fine tune the television until the pictures and sound are obtained
clearly.
7
If you cannot find the pictures and sound, or there is interference
from nearby channels, it may be necessary to change the setting
of the DVD-VCR output channel (see Setting the DVD-VCR
Output Channel on page 22 and Problems and Solutions on page
67).
8
When the picture and sound are perfectly clear, store this channel
at the desired programme position on the television.
Result:
That programme is now reserved for use with your
DVD-VCR.
DVD-90K_CHN-GB1.q 2003.4.11 11:14 AM 页面14
