24_
Washing programmes
Washing programmes
TURNING ON THE APPLIANCE
Starting a cycle wash
1.
Draw out the lower and upper basket, load the dishes and push them back..
It is recommended to load the lower basket fi rst, then the upper one (see the section entitled “
Loading
the dishwasher racks
”).
2.
Pour in the detergent (see the section entitled “
Using the detergent and water softener
”).
3.
Insert the plug into the socket. The power supply is 220-240 V~, 50 Hz, the specifi cation of the socket
is 15A 250 VAC. Make sure that the water supply is turned on to proper pressure.
4.
Close the door, press the
Power
button, to switch on the machine.
5.
Press the
PROGRAM (DÖNGÜ)
button, the wash program will be changed as follows direction:
Intensive
ECO (EKO)
Delicate
Express Wash
Pre Wash
If a wash program is selected, the response light will light. Then press the
Start/Pause
button, the
dishwasher begins to start.
When you press the
Start/Pause
button to pause during washing, the running indicator will stop
blinking and the dishwasher will beep every minute unless you press the
Start/Pause
button to start.
CHANGE THE PROGRAM...
Premise:
1.
A cycle that is underway can only be modifi ed if it has only been running for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refi lled (see the section entitled “
Fill the detergent in
dispenser
”).
2.
Press the
Start/Pause
button, the machine will be in standby state, press the
PROGRAM (DÖNGÜ)
button more than 3 seconds then you can change the program to the desired cycle setting.
If you open the door during a wash cycle, the machine will pause. The program light will stop blinking
and the buzzer will beep every minute unless you close the door. After you close the door, the machine
will keep on working after 3 seconds automatically.
If your model has broken memory function, the machine will go on to finish the selected program after
the power cut.
Add a dish
A forgotten dish can be added at any time before the detergent dispenser opens.
1.
Press the
Start/Pause
button and make sure to open the door slowly and carefully as there
is a possibility of injury from the hot steam inside the dishwasher.
2.
After the spray arms stop working, you can open the door completely.
3.
Add forgotten dishes.
4.
Close the door. The dishwasher will work after 3 seconds.
WARNING
: It is dangerous to open the door when washing, because the hot water may
scald you. If the door is opened while the dishwasher is running, a safety mechanism is
activated and stops the cycle.
DD81-01624A-04_EN (Turkey)_150904.indd 24
DD81-01624A-04_EN (Turkey)_150904.indd 24
2015-09-04 3:16:26
2015-09-04 3:16:26
