28_
Troubleshooting and information codes
Troubleshooting and
information codes
CHECK THESE POINTS IF YOUR DISHWASHER...
PROBLEM
POSSIBLE CAUSE
SOLUTION
Will not start.
The door is not closed completely.
The
Start/Reset
button is not
selected.
Check that the door is latched and
closed completely. Press the
Start/
Reset
button before closing the
door.
No programme is selected.
Select a programme.
The power cord is not connected.
Connect the power cord.
There is no water supplied.
Check that the water supply valve
is open.
The control panel is locked.
Deactivate the
Child Lock
function
to unlock the control panel.
Has a bad odour.
There is water left over from the last
cycle.
Add detergent without loading
dishes and run the
Auto
programme to clean the
dishwasher.
Has water remaining after the
programme has fi nished.
The drain hose is folded or clogged.
Straighten and unclog the hose.
Has food particles remaining
on the dishes.
An inappropriate programme was
been selected.
Select a programme according
to the soil level of the dishes as
directed in this manual.
The fi lter is contaminated or not
correctly fasten.
Clean the fi lter and make sure the
fi lters are fi tted properly.
No dishwasher detergent or not
enough detergent is being used.
Use an automatic dishwasher
detergent or use more detergent.
The pressure of the supplied water
is low.
The water supply pressure must be
between 0.05 MPa and 0.8 MPa.
Spray arm jets are clogged.
Clean the spray arms.
The dishes are improperly loaded.
Rearrange the dishes so they
have good water access and do
not interfere with spray arm and
dispenser operation.
The water is too hard.
Check salt refi ll indicator and refi ll
dishwasher salt.
Does not dry dishes well.
There is no rinse aid in the
dispenser or not enough rinse aid
was used.
Check the dispenser and add rinse
aid.
Check rinse aid setting.
Multi taps were used without
selecting the
Multi Tap
function.
Select the
Multi Tap
function or use
rinse aid.
Glasses and cups with concave
bottoms hold water. This water may
spill onto other items when you are
unloading.
After fi nishing the cycle, empty the
lower rack fi rst and then the upper,
this will avoid water dripping from
the upper rack onto the dishes in
the lower rack.
DD68-00135C-03_EN.indd 28
DD68-00135C-03_EN.indd 28
2013-06-26
2:56:56
2013-06-26
2:56:56