English - 13
02 SETTING UP
7
Sanitize
With the
Sanitize
option selected, the water temperature is increased to 70 ˚C
for high temperature sanitization.
You cannot select the
Sanitize
option if you select the Delicate cycle.
8
Dry+ (Child Lock)
Use this option when you want to dry your dishes more completely.
The temperature rises to 65 ˚C in the fi nal rinse cycle and dry time is increased.
If you select the this option, electricity consumption is increased.
*
Child Lock
: This option allows you to lock the buttons on the control panel -
except the
Power
button - so children cannot accidently start the dishwasher
by pressing the buttons on the panel. Only the
Power
button remains active.
To
lock
or
unlock
the buttons on the control panel, press and hold the
Dry+
(Child Lock)
button for three (3) seconds.
• When the Power is On : Press and hold the “
Dry+ (Child Lock)
” button for
three (3) seconds.
• When the Power is Off : Push the
Power
button fi rst, and then press and
hold the “
Dry+ (Child Lock)
” button for three (3) seconds.
• Child Lock remains active until you turn it off . You cannot select cycles or
options or start the dishwasher when Child Lock is on.
9
Display
Displays cycle time and remaining hours and minutes, Delay Start hours, and
check messages.
If an problem occurs during an operation, an check message is displayed with
a warning sound.
Refer to the
“Troubleshooting and information codes”
section on page
34
.
Child Lock
indicator
-
Turns on if the Child Lock is set (or the dishwasher is in the standby or
pause modes).
- Turns
off while the dishwasher is operating.
-
When Child Lock is on, the Child Lock indicator blinks for several
seconds if any button except the Power button is pressed.
Self Clean
indicator (for some models)
-
Turns on when the Self Clean option is enabled (or the dishwasher is
in the standby or pause modes), but turns off while the dishwasher is
operating.
-
Blinks for 5 seconds every 20 to 22 cycles.
-
The cycle counter disappears when the Self Clean operation is complete
or when the dishwasher reaches the 23rd cycle without the Self Clean
cycle being used. (The Reset or Self Clean operation is not counted by
the cycle counter.)
Rinse Refi ll
indicator
-
Turns on if the dishwasher runs out of rinse aid (or the dishwasher is in
the standby or pause modes).
- Turns
off while the dishwasher is operating.
Lack of salt
indicator (*applicable models only)
-
Turns on when the water softener runs out of salt. (or the dishwasher is
in the standby or pause modes.)
- Turns
off while the dishwasher is operating.
User Manual_DW9000H-FS_00158C-03_EN.indd 13
User Manual_DW9000H-FS_00158C-03_EN.indd 13
2015-03-24 5:30:14
2015-03-24 5:30:14
