30_
Cleaning and care
CLEANING THE SPRAY ARMS
It is necessary to clean the spray arms regularly as hard water
clog the spray arm jets and bearings. To remove the middle spray arm, hold the
nut, rotate the arm clockwise to remove it. To remove the lower spray arm, pull
out the spray arm upward. Wash the arms in warm and soapy water and use a
soft brush to clean the jets. Replace them after rinsing them thoroughly.
Open
CLEANING THE DOOR
To clean the edge around the door, you should use only a soft warm, damp
.
Also, never use abrasive cleaners or scouring pads on the outer surfaces because they will scratch the
finish. Some papers towels can also scratch or leave marks on the surface.
WARNING
: Never use a spray cleaner to clean the door panel for it could damage the door lock and
electrical components. It is not advised to use the abrasive agent or some paper towel because of the
risk of scratching or leaving spots on the stainless steel surface.
CARING FOR THE DISHWASHER
To clean the control panel use a lightly damp cloth then dry thoroughly. To clean the exterior use a good
appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
PROTECT AGAINST FREEZING
If your dishwasher is left in an unheated place during the winter:
1.
Cut off electrical power to the dishwasher.
2.
Turn off the water supply and disconnect the water inlet pipe from the water valve.
3.
Drain water from the inlet pipe and water valve. (Use a pan to catch the water)
4.
Reconnect the water inlet pipe to the water valve.
5.
Remove the fi lter in the tub the bottom and use a sponge sock up water.
Cleaning and care
DW5500M-02437D-00_EN.indd 34
DW5500M-02437D-0 _EN.indd 34
3/14/2017 5:30:49 PM
3/14/2017 5:30:49 PM
1
residue can
cloth