18 _ Disassembly and Reassembly
Part
Figure
Description
Bracket front
lower
Preparation:
• Make sure to disconnect the power, water
supply, and drain hose connections.
• Remove the upper & lower baskets in the
dishwasher.
• Pull out the dishwasher & carefully lay the
dishwasher down on its back.
• Remove the water supply line(& elbow).
Caution
Make sure to turn the water supply off before
removing the water supply line.
1. Remove the cover PCB and pull out the case
PCB without disconnecting wire connectors.
- When remove the PCB, lift up the two
(2clasps under the base by using a flat tip
screwdriver in a lever effect.
2. Pull out the case PCB and secure it to the base
using duct tape. Shown in the image to the left.
3. Remove the four (4) screws on both sides
of the bracket front lower.
4. The guide wire is attached to the bracket front
lower with three hooks. Use a pair of needle
nose pliers or flat screwdriver.
5. Using a Philips screw driver, lift up the each
clasp on both sides of the bracket front lower.
