Troubleshooting_43
Item
Related
Parts
Symptoms
Description
Information Display
Each time Hi-Temp Wash Key is pressed while "AS“ displays, it makes [SOUND_KEYPUSH] sound and changes in the
following order: n1 -> n2 -> n3 -> n4 -> n5 -> n1 -> n2-> n3...changes in a loop
- When Auto Key is pressed while the information display mode is on, it makes [SOUND_KEYPUSH] sound and
returns to Auto Mode.
n1: Version Display
When holding the following keys, the version displays alternating with "n1”:
- Normal Course Key: Sub PBA Version Display
- Heavy Course Key: Sub PBA Touch IC SW Version Display
- Express 60 Course Key: Model Option Display
n2: Inspection Code
Display
- Each time Normal (Europe: Eco) Key is pressed, the code on display changes in a loop starting from the last saved code:
C00 -> C10 -> C20 -> C30 -> C40 -> C50 -> C60 -> C00 -> ...
- Up to 7 inspection codes can be saved, any additional code overwrites the oldest code.
※
Inspection codes are saved according to [Dish Washer - Inspection Mode - Inspection Recall Mode].
1. Each time Heavy Key is pressed while inspection code is on display, the information about the condition which triggers
the inspection code displays in sequence.
ex: When C00 displays, it changes as follows: C00 -> C01 -> C02 -> C03 -> C04 -> C05 ->C06->...
When C10 displays, it changes as follows: C10 -> C11 -> C12 -> C13 -> C14 -> C15 -> C10->...
※
CX1: X indicates the order of inspection code on display.
C01: indicates the code ID which occurs most recently.
2. When the operation button is held for 7 seconds with the inspection code on display, it clears all the inspection code data.
n3: Smart Install
Auto
Mode Result Display
It determines based on the data saved in EEPROM.
- Smart Install Auto Mode is successfully completed: it is indicated by "OK"
- Smart Install Auto Mode is not successfully completed or not performed: it is indicated by "nG"
n4: Operation Cycle
Display
- The max. value is 9999 and it does not go any higher.
- When the finishing session is entered, Cycle Cnt increases unless Cancel & Drain has been enabled.
