20_
installing the dishwasher
STEP 11
WIRING CONNECTIONS
1.
Before connecting the power cable to the dishwasher, make sure the circuit breaker is off .
2.
In the junction box located at the front bottom right of the dishwasher, fi nd the three power
wires from the dishwasher including the grounding line.
3.
Pass the power cable through the strain relief, and then into the junction box (Figure 14).
4.
Connect the black wire of the dishwasher to the black wire of the power cable by insertng
both into a wire nut. and then rotating the wire connector as shown in Figure 15.
Connect the white wire to the white wire and the green to the green in the same manner.
5.
Recheck each wire to ensure it is connected correctly and securely.
Each colored wire should be connected to the corresponding wire of the same color.
White should be connected to white, black to black, and green to green.
6.
Replace the junction box cover on the dishwasher.
Recheck each wire to ensure it is connected correctly and securely.
Each colored wire should be connected to the corresponding wire of the same color.
installing the dishwasher
WARNING
Electrical Shock Hazard
To avoid electrical shock, do not work on an energized
circuit. Doing so could result in serious injury or death.
Only qualifi ed electricians should perform electrical
work. Do not attempt any work on the dishwasher
electric supply circuit until you are certain the circuit is
de-energized.
WARNING
Fire Hazard
To avoid a fi re hazard, make sure electrical work is
properly installed. Only qualifi ed electricians should
perform electrical work.
Black to black
White to white
Green to green
(Ground to ground)
Power cable
Junction box
Strain relief
<Figure 14>
<Figure 15>
DW9900M-00183A-01_EN.indd Sec3:20
DW9900M-00183A-01_EN.indd Sec3:20
1/2/2017 12:41:11 PM
1/2/2017 12:41:11 PM
