16
LOADING THE FILM
/COLOCACIÓN DE LA PELÍCULA
1. Open the back cover by sliding the release knob as shown above.
2. Insert a roll of film in the chamber. Do not force the film into position.
3. The film should lie flat.
4. Close the back cover. It will close with a “click”.
5. The film will automatically advance until the film counter reads “1”.
6. If a film is loaded incorrectly, the LCD panel will display an “E” warning signal. Reload the film following the steps
shown above.
NOTE
The camera automatically adjusts for ISO 50-3200 DX film.
When you use non-DX film, the camera will set the film speed at ISO 100.
Load the film in subdued lighting.
En
3
2
1
4
6
5
Film sensor
Summary of Contents for EVOCA 140S
Page 1: ...ENGLISH ESPAÑOL ...
