levels so as to use only the power required to reach the network. In general,
the closer you are to a wireless base station antenna, the lower the power
output.
Before a new model device is available for sale to the it does not exceed
the exposure limit established by the FCC. Tests for each model are
performed in positions and locations (e.g. near the body) as required by the
FCC.
For typical operations, this model has been tested and meets the FCC
exposure guidelines.
SAR information on this and other models can be viewed on-line at
http://www.fcc.gov/oet/ea/fccid/
. This site uses the FCC ID number
A3LSMT360
.
You can check the FCC ID on the rear case. Once you have the FCC ID
number for a particular device, follow the instructions on the website and it
should provide values for typical or maximum SAR for a particular device
SAR information can also be obtained at
Operating Environment
Remember to follow any special regulations in force in any area and always
switch your device forbidden to use it, or when it may cause interference or
danger. When connecting the device or any accessory to another device,