Troubleshooting 127
Q4
How do I receive a fax while the system is in power saving mode
(Rest mode) ?
A
To receive a fax in Standby Mode, you have to set it up as follows.
1.
The automatic fax reception function of the fax program needs to be activated.
(For more information, refer to the corresponding fax program manual.)
2.
Click Start > Control Panel > Network and Internet Connections.
3.
Under See Also, click Phone and Modem Options.
4.
In the Modems tab, select the installed modem, and click Properties.
5.
In the Power Management tab of the Modem Properties window, select the “With
this device, exit the computer from stand-by mode” item and then click OK.
The above setting enables the modem to turn on the system and receive a fax
when in power saving mode.
Wired LAN Related
Q1 <Wake On LAN> function
A
<Wake On LAN> is a function that activates the system in rest mode when a
signal (such as ping or magic packet commands) arrives from network (wired
LAN).
To use <Wake On LAN> function:
1.
Select My Network Places > View network connections from the Desktop.
2.
Click the right button on the touchpad over Local Area Connection, and select
Properties.
3.
Click Configure, and select Power Management tab. Select ’Allow this device to
bring the computer out of standby’, then click OK. Restart the system.
- If the system in rest mode is activated when there is no received signal, use the
system after disabling <Wake On LAN> function.
- If you turn the power off when <Wake On LAN> is disabled, the LAN LED
continues to be lit up.
- Connecting wired LAN while using wireless LAN may not execute <Wake On
LAN> function. Configure wireless LAN to ’Disable’ to use <Wake On LAN>
function.
1. Click on
My Network Place> View network connections
on the Desktop.
2. Right-click over
Wireless Network Connection
and select
Disable.
