Samsung HB6247SW, User Instructions

environment or to public health.

The symbol on the product or on the accompanying 

paperwork indicates that the appliance should not be 

treated as domestic waste, but should be delivered to 

a suitable electric and electronic appliance recycling 

collection point. Follow local guidelines when disposing of 

waste. For more information on the treatment, re-use and 

recycling of this product, please contact your local authority, 

domestic waste collection service or the shop where the 

appliance was purchased.

 INSTALLATION INSTRUCTIONS

Assembly and electrical connections must be carried out 

by specialised personnel.  

• Electric Connection

The appliance has been manufactured as a class II, therefore 

no earth cable is necessary. 

The plug must be easily accessible after the installation of 

the appliance.

If the appliance is equipped with power cord without plug, a 

suitably dimensioned omnipolar switch with 3 mm minimum 

opening between contacts must be fitted between the 

appliance and the electricity supply in compliance with the 

load and current regulations.

The connection to the mains is carried out as follows: 

BROWN = 

L

 line

BLUE = 

N

 neutral

• 

 The minimum distance between the support surfaces of 

the cooking pots on the cooker top and the lowest part of 

the cooker hood must be at least 

65 cm

.

If a connection tube composed of two parts is used, the upper 

part must be placed outside the lower part. 

Do not connect the cooker hood exhaust to the same con-

ductor used to circulate hot air or for evacuating fumes from 

other appliances generated by other than an electrical source.

Before proceeding with the assembly operations, remove 

the anti-grease filter(s) (Fig.5) so that the unit is easier to 

handle.

- In the case of assembly of the appliance in the suction version 

prepare the hole for evacuation of the air.

• 

 We recommend the use of an air exhaust tube which has 

the same diameter as the air exhaust outlet hole. If a pipe 

with a smaller diameter is used, the efficiency of the product 

may be reduced and its operation may become noisier.

•

 Installation

The following instruction should be followed to carry out the 

correct installation of the cooker hood.

1) Mounting of the cooker hood on the lower side of the 

cupboard.

2) Selection of the version  (extraction or filtration)

• Fixing the hood to the lower part of the wall cabinet

This type of appliance must be fitted inside a cabinet or inside 

another type of support structure. To fix it in place, use 4 screws  

A 

 which are suitable for the type of cabinet, making holes 

in accordance with the diagram shown in (fig. 1). To fit the 

 GENERAL

Carefully read the following important information regarding 

installation safety and maintenance. Keep this information 

booklet accessible for further consultations. 

The appliance has been designed for use in the ducting ver-

sion (air exhaust to the outside), filtering version (air circula-

tion on the inside ) or with external motor .

 SAFETY PRECAUTION

Take care when the cooker hood is operating simultane-

ously with an open fireplace or burner that depend on the air 

in the environment and are supplied by other than electrical 

energy, as the cooker hood removes the air from the environ-

ment which a burner or fireplace need for combustion. The 

negative pressure in the environment must not exceed 4Pa 

(4x10 

-5

 bar). Provide adequate ventilation in the environment 

for a safe operation of the cooker hood.

Follow the local laws applicable for external air evacuation. 

Before connecting the model to the electricity network:

- control the data plate (positioned inside the appliance) to as-

certain that the voltage and power correspond to the network 

and the socket is suitable. If in doubt ask a qualified electrician.

- If the power supply cable is damaged, it must be replaced 

with another cable or a special assembly, which may be ob-

tained direct from the manufacturer or from the Technical 

Assistance Centre.

- This device must be connected to the supply network 

through either a plug 

fused 3A 

or hardwired to a 

2 fase 

spur 

protected by 

3A fuse.

 Warning !

In certain circumstances electrical appliances may be a 

danger hazard. 

A) Do not check the status of the filters while the cooker 

hood is operating

B) Do not touch bulbs or adjacent areas, during or straight 

after prolonged use of the lighting installation.

C) Flambè cooking is prohibited underneath the cooker 

hood 

D) Avoid free flame, as it is damaging for the filters and 

a fire hazard

E) Constantly check food frying to avoid that the 

overheated oil may become a fire hazard

F) Disconnect the electrical plug prior to any maintenance.

G) This appliance is not intended for use by young children 

or infirm persons without supervision

H) Young children should be supervised to ensure they do 

not play with the appliance

I) There shall be adequate ventilation of the room when 

the rangehood is used at the same time as appliances 

burning gas or other fuels

L) There is a risk of fire if cleaning is not carried out in 

accordance with the instructions

This appliance conforms to the European Directive EC/2002/96, 

Waste Electrical and Electronic Equipment (WEEE). By making 

sure that this appliance is disposed of in a suitable manner, 

the user is helping to prevent potential damage to the 

ENGLISH

GB

- 18 -