appliance correctly, align the front panel of the cooker hood
with the cabinet door and adjust spacer
L
using screws
P
(fig.
2), then ensure the appliance meets the cabinet at the rear.
• Extraction through an outside wall
The appliance expels the fumes through an outside wallor a
duct. It is necessary to buy a telescopic pipe inaccordance
with the standards in use (inflammable) andconnect it to
flange B (Fig 3).
•
Recirculation
To transform the cooker hood from the extraction version
to the re circulating one ask your supplier for an activated
carbon filter. The filter must be fitted to the extracting group
cooker hood in the centre of the fan grille by twisting it by 90
degrees until it is gripped securely (Fig 6). For this operation
remove the anti-grease filter(s)
G
(Fig 5). The clean air is
returned into the room through a connecting tube passing
inside the cupboard and connected to the ring
B
(fig 4).
USE AND MAINTENANCE
•
We recommend that the cooker hood is switched on before
any food is cooked.
We also recommend that the appliance is left running for
15 minutes after the food is cooked, in order to thoroughly
eliminate all contaminated air.
The effective performance of the cooker hood depends on
constant maintenance; the anti-grease filter and the active
carbon filter both require special attention.
• The anti-grease filter
is used to trap any grease particles
suspended in the air, therefore is subject to saturation (the
time it takes for the filter to become saturated depends on
the way in which the appliance is used).
- To prevent potential fire hazards, the anti-grease filters should
be washed a minimum of every 2 months (it is possible to use
the dishwasher for this task).
- After a few washes, the colour of the filters may change. This
does not mean they have to be replaced.
If the replacement and washing instructions are not followed,
the anti-grease filters may present a fire hazard.
• The active carbon filters
are used to purify the air which is
released back into the room.
The filters are not washable or re-usable and must be replaced
at least once every four months.
The active carbon filter saturation level depends on the fre-
quency with which the appliance is used, the type of cooking
performed and the regularity with which the anti-grease
filters are cleaned.
• Clean the cooker hood frequently, both inside and outside,
using a cloth which has been dampened with denatured
alcohol or neutral,
non
-abrasive liquid detergents.
• The light on the cooker hood is designed for use during
cooking and not for general room illumination.
Extended use of the light reduces the average duration of
the bulb.
• Replacing halogen light bulbs (Fig. 7).
To replace the halogen light bulbs
B
, remove the glass pane
C
using a lever action on the relevant cracks.
Replace the bulbs with new ones of the same type.
Caution:
do not touch the light bulb with bare hands.
•Commands:
(pic.8)
Slider
the key symbols are explained
below:
A
= Light switch
A1
= Off key
A2
= On key
B
= Speed control
B1
= Off key
B2
= FIRST SPEED key
B3
= SECOND SPEED key
B4
= THIRD SPEED key
THE MANUFACTURER DECLINES ALL RESPONSIBILITY
FOR EVENTUAL DAMAGES CAUSED BY BREACHING THE
ABOVE WARNINGS.
- 19 -
Summary of Contents for HB6247SX
