34
English
¦
Setting Auto Initialize
When you clone settings from one TV to another, you clone both the guest side menu and hotel side menu settings:
Picture, Sound, Input, Channel, Setup, and Hotel Setup). This lets you set nearly all of the menu values on your hospitality
TVs to the same, standard settings. If you allow guests access to the guest side menus, for example the Picture menu,
they can change the settings in those menus so they are no longer standard. If you set the Setting Auto Initialize
function
to on, the TV automatically restores (initializes) any guest-side menu values to the cloned, standard values when the TV
is turned off and then turned on again. Note that Setting Auto Initialize works on cloned guest side menu values only.
Settings which have not been cloned are ignored.
The table below lists the settings that are restored to their cloned values when you set the Setting Auto Initialize function
to on.
✎
The menu item does not support depending on the models.
Menu Item
Picture
Picture Mode
Backlight
Contrast
Brightness
Sharpness
Colour
Tint (G/R)
Apply Picture Mode
Picture Size
Picture Size
Zoom/Position
4:3 Screen Size
PIP
Advanced Settings
Dynamic Contrast
Black Tone
Flesh Tone
RGB Only Mode
Colour Space
White Balance
Gamma
Motion Lighting
Picture Options
Colour Tone
Digital Clean View
MPEG Noise Filter
HDMI Black Level
Film Mode
LED Clear Motion
Picture Off
Reset Picture
Sound
Sound Mode
Sound Effect
Equaliser
Speaker Settings
Additional Settings
DTV Audio Level
Audio Format
Audio Delay
Dolby Digital Comp
Auto Volume
Reset Sound
