•
RJP (Remote Jack Pack)
: The RJP is a hardware module that has various audio and video inputs (A/V video, A/V
audio, PC and HDMI) and corresponding outputs. The corresponding outputs are connected from the RJP to the TV.
The RJP communicates with the TV via RS232. The RJP communicates with the TV by sending messages regarding
active or inactive sources.
– A group of
Hotel Option
menu items let you assign numbered priorities to the jacks of the RJP.
1
is the highest
priority and
2
is the lowest. When a guest connects external sources to the RJP jacks, the TV will automatically
switch between sources based on the priority you have assigned them in the
Hotel Option
menu. For example,
lets say AV is set to
1
and HDMI to
2
. If a guest has attached a device to the HDMI jack, and then plugs a device
into the AV jack, the TV automatically switches to the device plugged into the AV jack (the jack with the higher
priority). Note that a guest can also switch between devices manually by pushing a button on the RJP.
• To reset the RJP to its factory default state, press the AV and HDMI buttons simultaneously for 10 seconds. When all
button LEDs blink 5 times, the RJP reset is complete.
• The RJP will automatically turn off any LEDs after 5 minutes to avoid unnecessary light pollution in the hotel room.
The LEDs that were turned off will turn on again if the guest touches any of the buttons and the 5 minute timer
will restart. If the guest then touches another source button, the TV will change to the selected source and the
corresponding LED will be lit.
•
After the RJP reset or the TV turns off/on, it takes approximately 10 seconds to establish communications between
the TV and the RJP.
•
The following table shows the approximate time in seconds it takes to switch from the TV to an input source, based
on assigned or default priorities.
– When no inputs are connected.
Source
To Connect
AV
2 sec
HDMI
3.9 sec
– When two or more inputs are connected to the RJP and one of the input sources is disconnected and then
reconnected.
Source
Disconnect
To Connect
Total
AV
4.5
sec
2 sec
6.5
sec
HDMI
3.9 sec
3.9 sec
7.8 sec
–
If the RJP has all its live sources (AV, PC, and HDMI) connected, AV has been assigned the highest priority,
the RJP is in HDMI mode, and a guest removes and reconnects the AV source, the minimum time required to
switch to the AV source is 6.5 seconds.
– To play audio devices (Ipods, MP3 devices, etc.) through the RJP, you must turn
Music Mode AV
in the menu on.
– Music mode in the TA-7610 RJP is supported by the AV jack only.
HDMI Music Mode
is available for the
Guestlink RJP only.
English - 28
