Connecting the TV to a SBB or STB
ETH MODEM
TV Rear Panel
STB (SBB)
Data Cable
Connect the
DATA
port of the TV to the
ETH MODEM
port of the STB (SBB) with the Data cable.
•
The
ETH MODEM
port name that you connect the Data Cable to may differ depending on the SBB or STB type.
•
IR signals sent by the remote control to the TV or SBB / STB must meet the following specification to use IR pass
through function.
IR signal receiver specification
–
Band pass filter center frequency: 37.9
㎑
–
Carrier Frequency, Duty 50%
–
Minimum Burst Length (tburst): 12 pulses (316 us)
– Minimum Gap Time Between the burst (tburst gap): 16 pulses (422 us)
– Minimum Gap Time between the data commands (tpause): 25
㎳
List of Hospitality SI Vendors and compatible data cables supplied with the TV
•
Confirm you are using the correct data cable for your SI vendor. Refer to the code label on the data cables.
•
Contact your nearest dealer or your SI Vendor to buy the data cable not included in the TV.
1
6
1
2
3
4
5
Confirm the code on the Code Label.
TV side
STB (SBB) side
Cable code
Pin assign
REMARK
BN39-02462A
(Color : BLACK)
TV SIDE
1: NC
2: RX
3: TX
4: IR
5: GND
STB (SBB) SIDE
P1
P2
3
1
5
2
6
3
1
4
2
5
1: IR
2: GND
3: NC
4: NC
5: RX
6: TX
RED
GREEN
WHITE
BLACK
YELLOW
SAMSUNG and
others
BN39-02461A
(Color: LIGHT GRAY)
TV SIDE
1: CLK
2: RX
3: TX
4: IR
5: GND
P1
P2
6
1
5
2
3
3
1
4
2
5
1: IR
2: GND
3: TX
4: NC
5: RX
6: CLK
RED
GREEN
WHITE
BLACK
YELLOW
STB (SBB) SIDE
MTI
•
RX and TX notation is based on TV.
• Operation Specification of Data Cable(RJ12): RS232
English - 23
