08 Setting the Admin Menu
To access the
Admin menu
, press the
following buttons on the remote control:
1.
Press the
MUTE
button.
2.
Press the
1
button.
3.
Press the
1
button.
4.
Press the
9
button.
5.
Press the
Select
E
button.
To control the TV functions in the
Admin menu
, the TV has two modes, the
Standalone
mode and the
Interactive
mode.
The menu items that differ between the modes are listed below.
Menu items in the
Standalone
mode only:
•
SI Vendor
:
OFF
/
Movielink
/
Swisscom
/
SSCP
•
LYNK Cloud
,
LYNK HMS
,
Virtual Standby
,
Room Number
and its submenus.
Menu items in the
Interactive
mode only:
•
SI Vendor
: Samsung and other vendors.
All other items appear in both modes.
After a menu appears, follow these general directions to navigate and change values:
•
Use the directional buttons on the remote control to move from menu item to menu item.
•
Press the
Select
button on the remote control to select a menu item. The screen displays that menu item only.
•
Press the left or right directional button to change a value. The right directional button increases numerical values.
The left arrow button decreases numerical values.
•
When the screen is displaying one menu item, you can press the up or down directional button to display the next
or previous menu item.
•
Press the
RETURN
button to exit the current menu item and go to a higher menu level.
•
To exit a
Admin menu
, turn off the TV, and then turn it on again. Any changes you made are saved except changes
to SI (System Integration) vendor. For changes to SI vendor, you must turn the TV off, wait until the power indicator
at the bottom of the TV glows steadily. And then unplug the TV's power cord, wait for the power indicator to go off,
and then plug the TV's power cord in again.
To change menus between the
Interactive
mode and the
Standalone
mode, follow the steps below:
1.
Highlight the
Hospitality Mode
menu item in the top left corner of the menu.
2.
Press the
Select
button on the remote control. Only the
Hospitality Mode
menu item is displayed.
3.
Press the left or right directional button to change the
Hospitality Mode
item from
Standalone
to
Interactive
or
from
Interactive
to
Standalone
.
4.
Press the
RETURN
button on the remote control. The entire menu re-appears with your selection displayed in the
Hospitality Mode
item.
– After you have set the values in one TV, you can clone those values to multiple TVs.
– For more information about the USB cloning refer to page 37.
English - 31
