Setting Auto Initialize
O
Admin menu
>
Cloning
>
Setting Auto Initialize
When you clone settings from one TV to another, you clone both the guest side menu and hotel side menu settings:
Picture
,
Sound
,
Broadcasting
,
Admin menu
and so on. This lets you set nearly all of the menu values on your hospitality
TVs to the same, standard settings. If you allow guests access to the guest side menus, for example the
Picture
menu,
they can change the settings in those menus so they are no longer standard. If you set the
Setting Auto Initialize
function to on, the TV automatically restores (initialises) any guest side menu values to the cloned, standard values
when the TV is turned off and then turned on again. Note that
Setting Auto Initialize
works on cloned guest side menu
values only. Then unplug the TV, wait for the power indicator to go off, and then plug the TV in again. Settings which
have not been cloned are ignored.
The table below lists the settings that are restored to their cloned values when you set the
Setting Auto Initialize
function to on.
•
The menu items may not be supported depending on the models.
Menu Item
Picture
Picture Mode
Picture Size Settings
Picture Size
Fit to screen
Expert Settings
Backlight
Brightness
Contrast
Sharpness
Colour
Tint (G/R)
Apply Picture Settings
Digital Clean View
Auto Motion Plus
Settings
Auto Motion Plus
Judder Reduction
LED Clear Motion
Contrast Enhancer
Film Mode
Colour Tone
English - 40
