Troubleshooting
Samsung Electronics
4-17
4-2-2 How to Access Service Mode
1. General Remote
To Enter:
)
)
)
)
)
(Interval between key strokes: less than 3 sec)
To Exit:
)
2. Factory Remote
To Enter:
)
)
)
(Interval between key strokes: less than 3 sec)
To Exit:
)
Press the Factory key twice with a key stroke interval of more than 1 second (Pressing once enters Aging Mode)
3. Settings when entering Factory mode
- Sharp Screen (Dynamic), Color Tone (Cool1), Factory (Dynamic CE Off), DNIe(Off)
4. Adjustment Procedures
- Channel
* +
Key : Select an item.
- Volume
,&
Key : Adjust the value up or down.
- MENU Key
: Save the changes to the EEPROM and return to the higher-level mode.
- Using the Numeric (0~9) keys, you can select a channel.
- Using the SOURCE key, you can switch AV modes.
5. Initial SERVICE MODE DISPLAY State
-
The version of the firmware displayed at the bottom of the screen may differ and the firmware is subject to change for the
improvement of product functions.
-
If you have adjusted the settings in Service Mode, you have to reset the product.
-
If you exit Service Mode without reset, DNIe vlaue keeps Off regardless of setting up the user.
POWER OFF
MUTE
POWER ON
POWER OFF
POWER ON
POWER OFF
POWER ON
1
8
2
POWER ON
INFO
FACTORY Key
NTSC-RF
Calibration
Sub Micom Download
Option Byte
Checksum
White Balance
KS1410
W/B Movie
Dynamic Contrast
SVP-PX
EEPROM Access Count
FBE2
PDP Option
MSP44XX
RESET
NTP3000
Vol=0, B/S=Off, 10W, NONE
T-CAL42AUSC-xxxx Feb 7 2007
T-CAL42AUSS-xxxx Feb 7 2007
Summary of Contents for HPT4254 - 42" Plasma TV
